Hobbywing XRotor BLHeli_S 30 Amp Multi-Rotor Brushless ESC

This is the Hobbywing XRotor 30A Micro Brushless Drone ESC with BLHeli_S Firmware.

Features:

• Super Small & Light architecture
• F396 48MHz MCU
• BB2 MCU (EMF8BB21F16G)
• Premium MOSFETs (Toshiba MOSFETs for 20A & 35A ESCs, Fairchild MOSFETs for 30A ESCs)
• Ceramic capacitors
• 3-in-1 drive ICs, 3-ounce copper
• Ultra high efficiency & rapid response – 4 layers of PCBs and other quality components guarantees less heat.
• BLHeli_S Firmware Ready – The ESC supports the original BLHeli_S firmware. Users can flash or upgrade the firmware via the signal cable (on ESC) and program 4 ESCs simultaneously after connecting their flight controller to the BLHeli Suite software (if the flight controller uses the CleanFlight or beta flight firmware).
• Damped Light Mode & OneShot125 Mode Supported
• Damped light mode improves the motor retardation and allows users to brake the FPV drones more efficiently. Active-freewheeling technology improves driving efficiency, flight time and heat dissipation.
• Protocol Support:
• OneShot125 high speed throttle signal and regular throttle signal (within 500Hz) modes
• Oneshot 42 (41.4-83.3µs)
• Multishot(5-25µs)
• Regular PWM (1000-2000µs)throttle signals
• ESC + Motor combo available

Specifications:
Application: FPVs with 130-280mm Diagonal 
LiPo Power input: 2S-4S    
Continuous Current: 30A
Burst Current: 40A
BEC Output: NA
Input wires: 18AWG-100mm* (Red/Black)
Output Wire: Solder tabs (no wires)
Connectors (In/Out): no
Weight / Size: 7g / 24.0×13.9×5.5mm
*Note: All the wire length above is the original length, not the length you see from the outside.

This product was added to our catalog on December 7, 2016